Degassifier / Degasser Systems

In water demineralisation, a degasifier, or degasser, is often used to remove dissolved carbon dioxide after cation exchange. The most common degassers are of the so-called forced draft or atmospheric type.

After cation exchange, the bicarbonate and carbonate (if any) ions are converted to carbonic acid, or carbon dioxide. CO2 is soluble in water (see graph below), but it tends to escape into the air, much as it does in a glass of Coca-Cola when you stir it. Using a degasser to remove CO2 reduces the ionic load on the strong base anion resin, and the consumption of caustic soda is thus lower.

To be effective, the degasifier must be placed after the cation exchange column. Before cation exchange, the water is containing bicarbonate. After it, the cations in water (Ca++, Mg++ and Na+ principally) are converted to H+ ions, which combine with the HCO3— bicarbonate anions to produce carbonic acid (H2CO3 = CO2 + H2O). The reaction details are shown in the page about processes, under demineralisation.

In practice, the water coming out of the cation exchange unit is introduced into a column where it is sprinkled over a bed of filling material, often polypropylene shaped as saddles to leave a maximum volume of voids in the bed. Air is introduced at the bottom of the column by a blower, and escapes at the top, loaded with carbon dioxide from the water.

The solubility of CO2 in pure water is high: about 1.5 g/L or more than 30 meq/L at 25°C and atmospheric pressure (see graph). When you stir the water and divide it into small droplets in an atmospheric degasifier and blow air through the “rain”, the gas tends to move into the air because the partial pressure of CO2 in air is much below the equilibrium pressure. The residual CO2 after an atmospheric degasifier is 0.20 to 0.25 meq/L (typically 10 mg/L as CO2. Therefore such degassers are used when the bicarbonate concentration plus free carbon dioxide in the feed water to separate column demineralisation systems is at least 0.6 to 0.8 meq/L.

AKTIFPAK® Degassifiers can be manufactured from ;

  • FRP
  • HDPE
  • PP